There's nothing more annoying than spending hours cleaning your vehicle, only to be left with a nice, shiny vehicle that still has ugly, faded trim. Over the years, the sun beating down on your vehicle can take a toll on the plastic and rubber trim pieces. Add in all the chemicals that get splashed up from the road when it rains or snows and the harsh cleaners used in most carwashes, and your trim can start looking really bad, pretty fast.
The majority of trim restorers or trim coatings on the market are little more than re-labeled tire dressings or interior dressings.....mostly just silicone and water. They may look good for a little while, but the results soon wash away, leaving you with ugly, chalky, faded trim once again.
We wanted something different, something better, so we set out to create a new trim restorer.
And so BLACKOUT was born!
No silicones. No waxes. No oily, slippery messes!
BLACKOUT is a ceramic resin infused polymer that will help your faded trim look like new again and keep it looking great for months and months......GUARANTEED!
HOW TO USE:
Make sure surfaces to be coated are clean and free of any old waxes, oils, grease or any other contaminants that could interfere with proper application. A good panel prep such as an isopropyl alcohol (IPA) solution or a dedicated wax & grease remover is recommended. Like any coating, the better you prepare the surface, the better the end result. SHAKE BOTTLE. Apply a little BLACKOUT to an applicator pad, a little goes a long way. Coat the entire surface, let it soak in for a few minutes then wipe off any excess. If you'd like any additional coats, just wait a couple hours in between coats. Allow 24 hours to fully cure.
NOTE: Sometimes multiple coats are required on extremely dried out, faded trim, especially porous plastics, as they can soak up more product.
8 oz. Bottle....enough for many vehicles.
The majority of trim restorers or trim coatings on the market are little more than re-labeled tire dressings or interior dressings.....mostly just silicone and water. They may look good for a little while, but the results soon wash away, leaving you with ugly, chalky, faded trim once again.
We wanted something different, something better, so we set out to create a new trim restorer.
And so BLACKOUT was born!
No silicones. No waxes. No oily, slippery messes!
BLACKOUT is a ceramic resin infused polymer that will help your faded trim look like new again and keep it looking great for months and months......GUARANTEED!
HOW TO USE:
Make sure surfaces to be coated are clean and free of any old waxes, oils, grease or any other contaminants that could interfere with proper application. A good panel prep such as an isopropyl alcohol (IPA) solution or a dedicated wax & grease remover is recommended. Like any coating, the better you prepare the surface, the better the end result. SHAKE BOTTLE. Apply a little BLACKOUT to an applicator pad, a little goes a long way. Coat the entire surface, let it soak in for a few minutes then wipe off any excess. If you'd like any additional coats, just wait a couple hours in between coats. Allow 24 hours to fully cure.
NOTE: Sometimes multiple coats are required on extremely dried out, faded trim, especially porous plastics, as they can soak up more product.
8 oz. Bottle....enough for many vehicles.